Walk-in Coolers & Freezers
Walk-in cooler and freezer repair in Orlando.
A walk-in is not an appliance, it is a room, and it fails differently. The box holds temperature well enough that nobody notices a problem until the product at the back is already warm. By then the fault has usually been running for a day or two, and the repair is competing with a few thousand dollars of inventory.
Walk-in work splits into three places. Out on the roof or on a pad sits the condensing unit, where Orlando sun, afternoon storms and constant humidity are hard on coils, fan motors and contactors. Inside the box hangs the evaporator, where a failed defrost, a blocked drain line or a dead fan motor turns into a wall of ice. And then there is the envelope — panels, floor, door, hinges, closer, sweep gasket, strip curtain — which is where most of the wasted run time actually comes from, and the part people most often ignore.
Because a freezer box can hold more value than the equipment itself, the economics are different from a reach-in. A compressor that quits on a Friday night can cost more in product than the repair costs. That is why we put walk-ins on scheduled service: coil cleaning, refrigerant and superheat checks, door and gasket adjustment, drain line clearing, and written temperature records for the inspection file.
Call (689) 278-2614. If the box is climbing right now, say that first — it changes where the call sits in the day. For reach-ins, prep tables and display cases, see commercial refrigeration repair.
What we service
The box itself
- Walk-in coolers and walk-in freezers
- Combination cooler and freezer boxes
- Insulated panels, corner joints and floor repair
- Doors, hinges, closers, latches and inside safety releases
- Sweep gaskets, heated door frames and strip curtains
- Shelving, lighting and vapour-proof fittings
Refrigeration system
- Roof-mounted and remote condensing units
- Self-contained and top-mount systems
- Evaporator coils and fan motors inside the box
- Refrigerant leak detection, recovery and recharge
- Compressors, contactors, capacitors and start components
- Expansion valves and superheat adjustment
- Line sets, insulation and pipework after storm damage
Defrost and drainage
- Defrost timers, heaters and termination switches
- Drain lines, traps and heat tape on freezer boxes
- Ice build-up on coils, ceilings and door frames
Monitoring and records
- Temperature controllers and high-temperature alarms
- Probe calibration and verification
- Written temperature logs for health inspections